UPVC Pipes

UPVC Pipes Application for Blue Casing
UPVC Pipes Application for Agriculture

Water Storage Tanks
Solvent Cement
HDPE Pipes
Ring fit Pipes
Suction & Garden Pipes

Solvent Cement

The Solvent cement is used for jointing PVC pipes & Fittings. Proper care is always taken to ensure stringent quality checks on the product at all stages, without compromising on the quality. This is simple process for jointing RIGID PVC PIPES with moulded or fabricated Fittings. The tools required are a hacksaw with fine teeth, sandpaper, cotton waste, a soft brush, a knife and solvent cement. The jointing procedure is as under:
  • Inspect the pipe and fittings to ensure that they match perfectly
  • Cut the pipe square, using the hacksaw, clear burrs with knife and cotton waste
  • Rub with the Sandpaper outside of pipe and inside of fittings. Clean again with cotton waste
  • Apply solvent cement evenly with a soft brush on the outside of the pipe, to a width slightly more than the corresponding depth, as also on the inside of the fitting
  • Insert the pipe in fitting and turn it through 90ºC, to ensure uniform distribution of cement
  • Hold the joint for 2 minutes and ensure that the pipe does not slip out of fitting
  • Wipe out the excess cement from entire surface of the joint
  • The joint should be allowed to set, undisturbed. It should be pressure tested only after 24 hours.

Applications
  • It well be useful for jointing of PVC pipes and fittings
  • It can be used for jointing any of two of the products made from PVC material
Available sizes

25 lm, 50 ml, 100 ml, 250 ml, 500 ml, 1000 ml, 5000 ml

Sizes of Solvenet Box Packing Will be as under
25 ml - 576 nos 50 ml - 288 nos 100 ml - 144 nos 250 ml - 48 nos 500 ml -12 nos 1000 ml - 6 nos 500 ml - 4 nos
Safety Precautions
  • Avoid contact with skin
  • Always replace lids tightly after use
  • Store in a cool place away from direct sunlight
  • Do not breathe Solvent Cement vapours
  • Shake the solvent cement container thoroughly before use
  • Do not smoke while working with solvent cement, as it is highly inflammable
  • The excess solvent should b e wiped out from entire surface of the joint
Pipe

Dia

Approx. no. of

Joints / ltrs

Pipe

Dia

Approx. no. of

Joints / ltrs
20 330 140 36
25 280 160 27
32 245 180 25
40 190 200 15
50 140 225 12
63 125 250 9
75 105 280 7
90 80 315 5
110 55 400 2

 

CM Casing Pipes - Table - In All Dimensions & MM

General Dimensions

  Min Max Min Max
40 47.9 48.2 3.5 4.0
50 60.0 60.2 4.0 4.6
80 87.9 88.3 4.0 4.6
100 113.0 113.3 5.0 5.7
125 140.0 140.4 6.5 7.3
150 165.0 165.4 7.5 8.5
175 200.0 200.5 8.8 9.8
200 225.0 225.5 10.0 11.2
250 280.0 280.5 12.5 14.0